what to do when computer says preparing automatic repair

Troubleshooting Steps: Computer Stuck on "Preparing Automatic Repair" #

If you find yourself in a situation where your computer gets stuck on the "Preparing Automatic Repair" screen, don’t panic. This issue can occur due to various reasons, including corrupted system files, faulty hardware, or incompatible software. To resolve this problem, follow these troubleshooting steps:

1. Restart your computer: Begin by restarting your computer. Sometimes, a simple reboot can fix the issue and allow your computer to start up normally. Press the power button on your computer to turn it off, and then press it again to turn it back on.

2. Check for external devices: Disconnect any external devices connected to your computer, such as USB drives, printers, or external hard drives. Sometimes, a faulty device can cause conflicts during startup. After removing the external devices, try restarting your computer again.

3. Enter Safe Mode: If the problem persists, try entering Safe Mode. This mode allows you to start your computer with only the essential services and drivers, which can help identify and resolve any software conflicts. To enter Safe Mode, restart your computer and press the F8 or Shift+F8 key repeatedly until the Advanced Startup Options menu appears. From there, select "Safe Mode" and let your computer boot up.

Resolving Issues: Effective Solutions for Automatic Repair Loop #

Experiencing an automatic repair loop can be frustrating, as your computer keeps attempting to repair itself without success. However, there are several effective solutions you can try to break free from this loop:

1. Run Startup Repair: When your computer is stuck in an automatic repair loop, it may be due to an issue with the startup files. To resolve this, open the Advanced Startup Options menu (as described in the previous section), select "Troubleshoot," then "Advanced Options," and finally choose "Startup Repair." Let the repair process complete, and hopefully, your computer will start normally.

2. Use System Restore: If the automatic repair loop started after installing new software or making system changes, using System Restore can be helpful. In the Advanced Startup Options menu, select "Troubleshoot," then "Advanced Options," and choose "System Restore." Follow the on-screen instructions to restore your computer to a previous working state.

3. Refresh or Reset your PC: If all else fails, you can try refreshing or resetting your PC. Refreshing your PC keeps your personal files and settings intact while reinstalling the Windows system files. Resetting your PC, on the other hand, removes everything and reinstalls a fresh copy of Windows. Both options can be accessed through the Advanced Startup Options menu, under the "Troubleshoot" and "Reset this PC" options, respectively.

Remember, these troubleshooting steps and solutions may vary depending on the version of Windows you are using. It’s always a good idea to refer to the official Microsoft support documentation or seek professional assistance if you encounter any difficulties.